Send Message
Wuhan Fengfan International Trade Co.,Ltd. 86-27-85615818 info@fengfan.net
RC-90 Sn-Co-Zn Alloy Plating Chemicals Additives To Replace Chromium Plating

RC-90 Sn-Co-Zn Alloy Plating Chemicals Additives To Replace Chromium Plating

  • High Light

    Sn-Co-Zn Alloy Plating Chemicals

    ,

    RC-90 Alloy Plating Chemicals

    ,

    Sn-Co-Zn zinc alloy plating

  • Type
    Sn-Co-Zn Alloy Plating
  • Use
    Replace Chromium Plating
  • Model
    Electroplating Additive
  • Place of Origin
    CHINA
  • Brand Name
    FENGFAN
  • Model Number
    RC-90

RC-90 Sn-Co-Zn Alloy Plating Chemicals Additives To Replace Chromium Plating

Additive for RC-90 Sn-Co-Zn Alloy Plating

1. Properties

1. The deposit appearance is similar to chromium deposit. The anti-corrosion and brightness can compare with chromium deposit, the covering ability is superior to standard chromium plating.

 

2. The energy consumption is lower than that of chromium plating.

 

3. Suitable for general barrel plating on small parts, production efficiency can increase.

 

4. The technique is used for light industrial products without special toughness demands. It can get big economic benefit due to being as a substitute for chromium plating.

 

2. Bath Composition and Operating Condition

Stannous Chloride ( SnCl2.H2O) 20~30g/L
Cobalt Chloride ( CoCl2) 8~12g/L
Zinc Chloride ( ZnCl2) 5~10g/L
Potassium Pyrophosphate ( K4P2O7) 220~280g/L
RC-90 Additive 20~30ml/L
RC-90 Stabilizer 4~8g/L
PH 8.5~9.5
Temp. 20~45℃
Dk 0.1~2A/dm2
Anode Pure tin plate

3. Bath Make-up

1. Dissolve calculated volume of Potassium Pyrophosphate (K4P2O7) into 50-60℃ hot water of 1/2 of total volume.

2. Add Stannous Chloride (SnCl2.2H2O) into the above solution slowly, while agitating till it dissolves completely.

3. Add Cobalt chloride (CoCl2) and Zinc chloride (ZnCl2) into tank, while agitating till they dissolve completely, then add water up to the volume.

4. Add 1g/L activated carbon, heat it to 40℃, agitate for 1 hour, rest it for 24 hours, then filter it.

5. Add RC-90 stabilizer.

6. Add RC-90 additive, adjust PH, electrolyze for several hours, then try plating.